Caller Id Display Change - Iwatsu ENTERPROSE-CS Owner's Manual

To make a call by automatically dialing the stored Caller ID or ANI
number:
 With a call record displayed, Do one of the following:
 For station: Press the USAS key a second time, or press FLT, OPT, or
COL
 For trunk group: Press the USAT + trunk group number or USAT key
a second time, or press FLT, OPT, or COL
To add digits to the displayed number before calling out:
 With a call record displayed,
 Dial the additional digits to be added to the outgoing number (the added
digits do not appear on the display when entered), then
 Do one of the following:
 For station: Press the USAS key a second time, or press FLT or COL
 For trunk group: Press the USAT + trunk group number or USAT key
a second time, or press FLT or COL
 Press USAT, USAT
To delete saved call information from system memory:
 With a call record displayed, press the UST key

Caller ID Display Change

The information displayed on the station LCD during incoming ringing, call in
progress, incoming forwarded call ringing, and camped-on/transferred call
ringing may be changed by pressing a CID DISPLAY CHANGE key. This
feature may be used only incoming calls on Caller ID/ANI or DNIS lines. Ten
different display modes are available. The display mode is determined by the
type of call and status of call.
During call in progress:
 Press the CID DISPLAY CHANGE key
IWATSU TELEPHONE USER GUIDE - 125