Trunk Interface Cards; Ix-8Untk-1 Universal Analog Trunk Card; Eight-Port Digital Station/ Four-Port Caller Id Trunk Card; Ix-400-2 Four-Port Analog Caller Id Trunk Expansion Module - Iwatsu ENTERPROSE-CS Owner's Manual

Trunk Interface Cards

Trunk interface cards interface the system universal ports to the individual
outside trunks. Four types of cards are available to meet various outside
communication requirements.

IX-8UNTK-1 Universal Analog Trunk Card

The IX-8UNTK-1 card is an analog trunk card that was developed for
improving the speech quality of IP phones over analog trunks. This card
employs a linear CODEC and a DSP-based echo canceller. The IX-8UNTK-1
card is equipped with eight circuits for analog trunks and Caller ID. Each of
the eight trunks can be set as Loop Start or Ground Start as required. This card
is UL approved for the IX-CME, IX-EXPME1, and IX-EXPME2 ECS
expansion cabinets only.

Ports: 8 ports/card

Additional Power: -48Vdc (IX-DCDCM) when used as ground start
trunks are equipped.

Features: Loop/Ground start selection, 600/900 Ohm impedance
selection, Long/Short distance selection
IX-408 Eight-Port Digital Station/ Four-Port Caller ID
Trunk Card
See description under Station Interface Cards.
IX-400-2 Four-Port Analog Caller Id Trunk Expansion
Module
The IX-400-2 Caller ID trunk module is connected to the IX-8PSUB-2 card
and interfaces four caller ID loop start circuits.
Ports: 4 ports/card
Additional Power: None
Features: 600/900 Ohm impedance selection.
IX-400 Four-Port Analog Caller Id Trunk Expansion
Module
The IX-400 Caller ID trunk module is connected to the IX-044 card and
interfaces eight caller ID loop start circuits.
Ports: 4 ports/card
Additional Power: None
Features: 600/900 Ohm impedance selection, Long/Short distance selection
GENERAL DESCRIPTION - 42