Headset Connection - Iwatsu ENTERPROSE-CS Owner's Manual

Headset Connection

ECS telephones may operate with a headset instead of the handset (receiver).
48
Most Iwatsu telephones have an integrated headset jack on the back of the
phones. Phones without an integrated headset jack requires the handset to
remain in the cradle of the telephone and the headset control key to be
switched to the ON position.
Note:
Refer to the Bluetooth section in this chapter for information regarding
Bluetooth headsets.
To make a call:
 Press the key representing the type of call you wish to place
 Wait for the dial tone
 Dial the desired number
To answer a call:
 Press the key representing the incoming call
To hang-up:
 Press the Release key RLS
To transfer a call:
 Press the Transfer key TRAN
 Dial the desired extension number, or, press the key representing the
desired extension if assigned as a Multipurpose key
 Press the Connect key CNCT
Hot Line
If your phone is programmed to have this feature every time you lift the
receiver or press the Speaker key SPKR a call will be placed to a
predetermined extension.
 Lift the receiver, or, press the Speaker key SPKR
Hotel/Motel Features
The ECS software includes features specific to the Hotel/Motel industry.
These features include Intercom Call Restriction, Message Waiting
Notification, Room Status indication and Wake-Up Call. Each feature is
described below.
48
Check the specification of the Iwatsu telephone model you are using to determine if it
supports a headset jack.
IWATSU TELEPHONE USER GUIDE - 137