Night Mode - Iwatsu ENTERPROSE-CS Owner's Manual

Multiple Ringing Mode Conditions
 Legacy Telephones: Legacy telephones, Attendant Consoles, and ICON
Series 5800/5900 telephones, assigned as attendant positions cannot
access the Day-2 and Day-3 modes. These telephones can only switch
between Day (Day-1) and Night modes. The legacy Day / Night mode
operation remains the same as in previous software versions.
 ACD Night: This enhancement will not affect ACD functionality, ACD
Night maintains the existing toggle operation (Day or Night).
 Universal Night Answer (UNA): Universal Night Answer will operate
only if a system is in the Night Mode.
 Attendant Intercept (UCD): Attendant Intercept will operate if a system
is in the Day-1, Day-2 or Day-3 mode (Night Mode not supported).
 Iwatsu ICON Series Self-labeling key name change is not supported
with the Multiple Ringing Mode.

Night Mode

Allows you to change the ringing termination point for outside lines. This
alternate point might be a loud bell, a phone or a group of phones. A
programming option may be enabled to allow the ECS to automatically switch
to the Night Mode at a certain time; however, you must manually switch the
system back to the normal mode.
To place the system in Night Mode operation:
 Press the Speaker key SPKR
 Wait for the dial tone
 Press the Night Mode key NIGHT and the lamp for that key will be
solid red
 Wait for a confirmation tone
 Press the Speaker key SPKR
To disable Night Mode operation:
 Press the Speaker key SPKR
 Wait for the dial tone
 Press the Night Mode key NIGHT and the lamp for that key will be off
 Wait for a confirmation tone
 Press the Speaker key SPKR
ATTENDANT POSITION USER GUIDE - 189