®
Invacare
- TDX-SP / TDX-SP N
8.9.2
Replacing the tilt module (max. < 30°) (without a lifter)
Note
This chapter discusses how to replace a tilt module (max. > 30°) on a chair without a lifter.
Similar tasks are described In the following chapters:
● Replacing only the seat support – chapter 8.8
● Replacing a tilt module (max. > 30°) – chapter 8.9.1
● Replacing a combined lifter/tilt module – chapter 8.9.3
● Replacing only the tilt actuator – chapter 8.9.4
● Replacing only the lifter actuator – chapter 8.9.5
WARNING: Danger of crushing!
The seat is very heavy. Injury hazard to hands and feet!
● You should seek help from a second person.
Requirements:
● 1/2" socket spanner
● 13 mm jaw spanner
● 4 mm Allen key
● 6 mm Allen key
● oblique pliers
● cable binder
Note
Make a careful note of the seat settings. Mark the fitting positions, alignments etc, and take
photos with a digital camera if necessary.
Every change to the seat settings influences the centre of gravity of the mobility device. If the
seat settings are changed, the anti-tip system settings must be checked and readjusted if
necessary as described in Chapter 8.16.5.
Removing the tilt module:
●
If possible, tilt the seat with the tilt module as far as possible to the rear.
●
Switch the controller off.
●
Remove the batteries as described in Chapters 8.2.1 and 8.2.2/8.2.3.
The actuator module for the lifter and the tilt actuators is fitted to the front edge of the seat support.
●
Remove the two knurled screws (1) including washers.
●
Remove the cover (2).
SERVICE MANUAL
79