Replacing Tilt Module / Lifter Module; Replacing The Tilt Module (Max. > 30°) (Without A Lifter) - Invacare TDX-SP Service Manual

SERVICE MANUAL
8.9

Replacing tilt module / lifter module

Note
Depending on which tilt module is installed, either chapter 8.9.1 or ● applies. You can determine
the type of tilt module by the maximum adjustment angle it allows:
● Max. angle is larger than 30°: See chapter 8.9.1
● Max. angle is smaller than 30°: See chapter ●
8.9.1 Replacing the tilt module (max. > 30°) (without a lifter)
Note
This chapter discusses how to replace a tilt module (max. > 30°) on a chair without a lifter.
Similar tasks are described In the following chapters:
● Replacing only the seat support – chapter 8.8
● Replacing a tilt module (max. < 30°) – chapter 8.9.2
● Replacing a combined lifter/tilt module – chapter 8.9.3
● Replacing only the tilt actuator – chapter 8.9.4
● Replacing only the lifter actuator – chapter 8.9.5
WARNING: Danger of crushing!
The seat and the tilt module are very heavy. Injury hazard to hands and feet!
● You should seek help from a second person.
Requirements:
● Phillips screwdriver size 2
● 1/2" socket spanner
● 13/32" socket spanner
● 5/32" Allen key
● oblique pliers
● cable ties
Note
Make sure you have noted the seat settings. Mark the fitting positions, alignment etc. If
necessary, take photos with a digital camera.
Any changes to the seat settings influence the centre of gravity of the mobility aid. If changes are
made to the seat settings, the anti-tip system settings must be checked and readjusted if
necessary, as described in Chapter 8.16.5.
Removing the tilt module:
● Remove the legrests.
● Remove the seat cushion.
● Activate the tilt module to tilt the seat a little towards the rear.
● Remove the rear panel as described in Chapter 8.1.2.
74
®
Invacare - TDX-SP / TDX-SP N