®
Invacare
- TDX-SP / TDX-SP N
7.2
Testing the electro-mechanical parking brake
Note
This test should only be carried out on mobility aids with conventional motor/transmission units.
Requirements:
● Phillips screwdriver size 2
● digital multimeter with resistance measurement
●
Remove the rear panel as described in Chapter 8.1.2.
●
Pull the motor plug (3) out of the electronic module.
●
Connect the digital multimeter to the adjacent central motor plug contacts (3) and measure the
resistance between the contacts.
●
If there is a defect, replace the motor and send it to Invacare® Service for inspection or repair.
Note
A resistance of between 40 and 80 ohms indicates an intact brake.
A resistance of 0 ohms or a very high resistance (mega-ohms or infinity) indicates a short-circuit,
a bad connection or a defective brake.
SERVICE MANUAL
33