®
Invacare
- TDX-SP / TDX-SP N
8.20
Rear wheel suspension
8.20.1 Removing the rear wheel suspension
WARNING: Danger of crushing!
The mobility device is very heavy. Injury hazard to hands and feet!
● You should seek help from a second person.
Injury hazard caused by uncontrolled movement of the mobility device!
● Switch the power supply off (ON/OFF key).
● Engage the drive.
● Before raising the vehicle, secure the wheels by blocking them with wedges.
Requirements:
● 5/16" Allen key
● 5/32" Allen key
● Phillips screwdriver size 2
● torque wrench 0 - 20 Nm (or similar)
● torque wrench 20 - 80 Nm (or similar)
● oblique pliers
● cable ties
● two long wooden blocks, min. 14 x 14 x 30 cm
●
Lift the mobility aid up on one side and get a second person to place a wooden block around
14 cm high underneath it so that the wheels are suspended freely.
●
Repeat the same procedure on the other side of the mobility aid.
●
Remove the rear panel as described in Chapter 8.1.2.
●
Ensure you note the cable routing carefully. If necessary, take photos with a digital camera.
●
Remove all cables and cable ties which are fixed to the wheel suspension or which could get
in the way during work.
SERVICE MANUAL
147