SERVICE MANUAL
●
Make a marking on the motor and the carbon brushes in order to guarantee correct refitting.
●
Remove the carbon brushes complete from the mounting (2).
●
Check the carbon brushes and springs for the level of wear, broken components or
discolouration.
Refitting the carbon brushes:
●
Depending on the condition of the brushes and the spring:
- either replace the brushes in exactly the same position from which they were taken or
- fit new brushes.
●
Replace the plastic caps and tighten them.
●
Refit the top walking beams as described in Chapter 8.18.2.
●
Refit the bottom walking beams as described in Chapter 8.17.
●
Refit the drive wheels as described in Chapter 8.13.1.
Note
The following procedure is necessary to run the carbon brushes in after replacement and to
therefore guarantee maximum performance.
WARNING: Risk of accidents!
Hazards to workers, surroundings and mobility device!
● Do not leave the mobility device unattended during the following procedure!
● Stellen Sie sicher, dass BEIDE Antriebsräder angehoben werden und den Boden nicht
berühren können.
● Secure the area.
●
Lift the mobility aid up on one side and get a second person to place a wooden block around
14 cm high underneath it so that the drive wheel is suspended freely.
●
Repeat the same procedure on the other side of the mobility aid.
●
Allow the motors to run in the forward direction for an hour.
●
Allow the motors to cool down for 30 minutes.
●
Allow the motors to run in the reverse direction for an hour.
●
Lift the mobility aid off the wooden blocks.
144
®
Invacare
- TDX-SP / TDX-SP N