Invacare TDX-SP Service Manual page 153

®
Invacare - TDX-SP / TDX-SP N
● Ensure that the rear springs are compressed:
Block method:
● Lift the suspension arm and place wooden blocks or similar underneath it until the springs
are pressed together and the nylon spacer (2) can be fitted into the recesses provided in
the suspension (6).
Clamp method:
● Remove the rubber caps (9).
● Press the springs together with a joiner's clamp or similar suitable clamp until the nylon
spacer (2) can be fitted into the recesses provided in the suspension (6).
● Fit the two bolts (3) including the nylon spacer (2).
● Tighten the bolts to 8.5 Nm.
● Replace the two rubber caps (9) if necessary.
● Reinsert all the necessary plugs and fix the cables with cable ties as previously (see also
Chapter 8.2.8).
● Refit the rear panel as described in Chapter 8.1.2.
● Lift the mobility aid off the wooden blocks.
● Check all the mobility aid functions.
● If necessary, carry out adjustments to the setting screw on the anti-tip system as described in
Chapter 8.16.5.
SERVICE MANUAL
153