Electronic Module; Replacing The Remote; Replacing The Electronic Module - Invacare TDX-SP Service Manual

®
Invacare - TDX-SP / TDX-SP N
8.6

Electronic module

8.6.1

Replacing the remote

Note
Replacing the remote is very easy and is not described in detail.
However, please note that when replacing an REM remote in connection with a DX, ACS or
ACS 2 electronic module, the subsequent selection of drive program should be carried out as
described in Chapter 8.6.3.
8.6.2

Replacing the electronic module

Note
However, please note that when replacing an REM remote in connection with a DX, ACS or
ACS 2 electronic module, the subsequent selection of drive program should be carried out as
described in Chapter 8.6.3.
The various electronic modules can be fitted to the mobility aid with a range different remotes . The
possible electronic modules are described in Chapter 4.2.
Replacement is described below using the ACS 2 electronic module with optional lighting PCB and
optional actuator module as an example. The procedure for other electronic modules is the same.
The only difference is the plug positions.
WARNING!
Any changes to the drive program can affect the driving characteristics and the tipping
stability of the mobility aid!
● Changes to the drive program may only be carried out by trained Invacare® specialist
dealers!
● Invacare® can only give a warranty for safe mobility aid driving behaviour - especially tipping
stability - for unaltered standard drive programs!
Note
All electronic modules are delivered with a standard drive program. If you have carried out
customer-specific modifications to the drive program, you will have to make these changes again
after installing the new electronic module.
Requirements:
● 5/16" Allen key
● Phillips screwdriver size 2
● socket spanner, 8 mm
● To adapt the drive program:
programming software or hand programming device and system installation manual, available
from Invacare®.
SERVICE MANUAL
61