SERVICE MANUAL
8.6.4
Replacing the operating hours counter / connecting cable
Requirements:
● 10 mm socket wrench
The operating hours counter is located on the rear cover (2).
Removing the operating hours counter:
●
Switch the electronic system of the wheelchair off.
●
Remove the rear cover as described in chapter 8.1.2.2.
●
Loosen and remove the nut (5) including the locking washer (4) using a 10 mm socket wrench.
●
Pull the mounting bracket (2) off of the threaded rod (3).
●
Remove the retaining frame (6).
●
Pull the operating hours counter forwards out of the rear cover.
●
Disconnect the two plugs of the cable (not shown in the illustration) from the pins (-) & (+).
●
Replace the operating hours counter and cable respectively.
66
®
Invacare
- TDX-SP / TDX-SP N