SERVICE MANUAL
8.9.1.2
Replacing the tilt module angular sensor
Requirements:
● socket spanner, 10 mm
● oblique pliers
● cable ties
Removing the tilt module angular sensor:
●
Undo and remove the two cap nuts (1) on the right-hand plastic cover (2) with a 10 mm socket
spanner.
●
Remove the plastic cover.
●
Undo the cable and the plug from the angular sensor (1). Remove any cable ties which are
fitted.
●
Remove the cable ties holding the angular sensor.
●
Replace the angular sensor.
Refitting the angular sensor:
●
Refit the parts later in reverse order.
78
®
Invacare
- TDX-SP / TDX-SP N