Rear Cover With An Operating Hours Counter - Invacare TDX-SP Service Manual

®
Invacare - TDX-SP / TDX-SP N
8.1.2.2

Rear cover with an operating hours counter

Requirements:
● Phillips screwdriver size 2
Note
This chapter explains how to open the rear cover if an operating hours counter is installed. The
procedure for opening the rear cover with no operating hours counter installed is described in
chapter 8.1.2.1.
Refitting the front cover panel:
● Undo the three Phillips screws (1) on the rear cover panel (7).
● Carefully loosen the rear cover. Pay attention to the cable of the operation hours counter.
● Take note of the positions of the cables and sockets. Mark the plugs and sockets or take a
photo with a digital camera.
● Detach the cable of the operating hours counter from the drive motor.
● Remove the rear cover panel.
Refitting the rear cover panel:
● Refit the parts in reverse order.
● Now tighten all the screws finger-tight again.
SERVICE MANUAL
37