SERVICE MANUAL
●
Open the lifter energy chain:
- lift the cover (1) up.
- pull the tab (2) out of the cover.
- repeat this part by part.
●
Remove the two cable ties which fix the cable to the ends of the energy chain.
●
Pull the cable out of the energy chain.
●
Undo the screws (1) with a crosshead screwdriver.
●
Remove the energy chain (2).
●
Undo the screws (4) with a crosshead screwdriver.
●
Remove the magnets (3).
●
Remove the sensor (5).
●
Undo the four bolts (2) on both sides of the seat using a ½" socket spanner.
●
Lift the lifter/tilt module off the battery case.
Refitting the lifter/tilt module:
●
Refit the lifter/tilt module in the reverse sequence.
●
Tighten the connecting bolts between the lifter/tilt module and the battery case to 18 Nm.
84
®
Invacare
- TDX-SP / TDX-SP N