Rear Brake Pedal Removal And Installation - Suzuki ltz 400 Service Manual

4A-15 Brake Control System and Diagnosis:

Rear Brake Pedal Removal and Installation

Removal
1) Remove the right footrest mud guard. Refer to
"Exterior Parts Removal and Installation in Section
9D (Page 9D-4)".
2) Remove the right footrest. Refer to "Footrest
Removal and Installation in Section 9E (Page 9E-2)".
3) Remove the cotter pin (1), washer (2) and pin (3).
2
1
4) Remove the rear brake light switch spring (4) and
brake pedal spring (5).
5
5) Remove the rear brake pedal pivot nut (6), washer
(7) and bolt (8).
7
6
B933H24106015
3
I933H1410050-02
4
I933H1410051-01
8
I933H1410052-02
6) Remove the rear brake pedal (9) and O-rings (10).
10
9
Installation
Install the rear brake pedal in the reverse order of
removal. Pay attention to the following points:
CAUTION
!
The removed cotter pin and O-rings must be
replaced with new ones.
• Apply grease to the O-rings and rear brake pedal
pivot.
: Grease 99000–25160 (Water resistance
grease or equivalent)
• Install the brake pedal spring and rear brake light
switch spring properly. Refer to "Rear Brake Pedal
Construction (Page 4A-14)".
• After installing the rear brake pedal, check the rear
brake height. Refer to "Brake System Inspection in
Section 0B (Page 0B-17)".
10
I933H1410053-01
I933H1410054-02