Balancer Shaft And Balancer Driven And Drive Gear; Starter Clutch - Suzuki QuadRacer LT-R450 Service Manual

BALANCER SHAFT AND BALANCER
DRIVEN AND DRIVE GEAR
INSPECTION
Inspect the balancer shaft and balancer driven and drive gear
for wear or damage. If any defects are found, replace the defec-
tive part.

STARTER CLUTCH

INSPECTION
Install the starter driven gear onto the starter clutch and turn the
starter driven gear by hand to inspect the starter clutch for a
smooth movement. The gear turns one direction only. If a large
resistance is felt to rotation, inspect the starter clutch for dam-
age or inspect the starter clutch contacting surface of the starter
driven gear for wear or damage.
If they are found to be damaged, replace them with new ones.
DISASSEMBLY
• Hold the rotor using the special tool and remove the bolts.
& 09930-44520: Rotor holder
REASSEMBLY
• Install the starter clutch in the proper direction as shown.
NOTE:
When installing the starter clutch onto the rotor, make sure that
the arrow mark A in the bearing faces to the rotor.
• Apply engine oil to the starter clutch.
• Apply a small quantity of THREAD LOCK SUPER "1322" to
the starter clutch bolt.
* 99000-32110: THREAD LOCK SUPER "1322"
(or equivalent thread lock)
ENGINE 3-41