Cable Connections - Printronix P3000 Series User's Reference Manual

Cable Connections

Perform the following steps and refer to Figure 10–4 and Figure 10–5 to connect the cables to the ped-
estal model and floor cabinet model printers, respectively.
1. Verify that the voltage shown on the printer ID label (A) is within the same range as the site line
voltage and that the proper power cord has been selected. Refer to the Power Requirements sec-
tion on page 10–1.
2. Make sure the printer power switch (B) is set to OFF (0).
3. Connect the power cord between the printer's AC power connector (C) and the AC line recepta-
cle.
4. Connect the interface cable (customer supplied) between the appropriate printer interface con-
nector (D) and the host computer. Refer to the Interfaces chapter for a complete description of the
printer interface.
10–6
Figure 10–4. Cable Connections – Pedestal Models
Installation