Setting Up Vtrak With The Cli - Promise Technology VTRAK E610f Product Manual

Setting up VTrak with the CLI

1. Type the following string to set the system date and time, then press Enter.
administrator@cli> date -a mod -d 2006/08/25 -t 14:50:05
In the above example, the date and time are included as examples only.
Your values will be different. Use yyyyy/mm/dd for the date and a 24-hour
clock for the time.
2. Type the following string to set the Management Port IP address and other
settings, then press Enter.
administrator@cli> net -a mod -t mgmt -s "primaryip=192.168.10.85,
primaryipmask=255.255.255.0, gateway=192.168.10.1"
In the above example, the IP addresses and subnet mask are included as
examples only. Your values will be different.
If you prefer to let your DHCP server assign the IP address, type the
following string, then press Enter.
administrator@cli> net -a mod -t mgmt -s "dhcp=enable"
Note that the IP address described above belongs to the VTrak subsystem,
not to the RAID controller. Use this IP address to log into the VTrak over your
network.
3. To verify the settings, type net and press Enter.
administrator@cli> net
===========================================
CId
===========================================
Virtual
Each RAID controller has an IP addresses for access when the controller
goes into maintenance mode. Maintenance mode is only for remedial action
in the event of a problem with the controller. See "Controller Enters
Maintenance Mode" on page 298 for more information.
4. Type the following string to set the Maintenance Mode IP address and other
settings, then press Enter. You must set each controller separately.
administrator@cli> net -a mod -t mgmt -m -c 1 -s
"primaryip=192.168.10.101, primaryipmask=255.255.255.0,
gateway=192.168.10.1"
administrator@cli> net -a mod -t mgmt -m -c 2 -s
"primaryip=192.168.10.102, primaryipmask=255.255.255.0,
gateway=192.168.10.1"
Port Type IP
Mgmt 192.168.10.85 255.255.255.0 192.168.10.1
Mask
37
Chapter 3: Setup
Gateway Link
Up