Promise Technology VTRAK E610f Product Manual page 44

VTrak E-Class Product Manual
Configuring JBOD Expansion
To expand the number of disk drives:
1. On the E610s or E310s controller, connect the SAS expansion port (a
subtractive-routed port) to the CN1 (a table-routed port) on one of the I/O
modules of the first J300s unit. See Figure 20.
2. Connect CN3 (a subtractive-routed port) on the first J300s unit to CN1 on
one of the I/O modules of the next J300s unit.
3. Connect the remaining J300s units in the same manner.
Figure 20.JBOD data connections. The E310s is shown. The E610s is
similar
Host PC or Server
SAS expansion
port
You can expand a SAN system with no single point of failure. See Figure 21.
Such an arrangement requires:
• Two SAS HBA cards in each Host PC or Server
• A network switch (not shown)
• A network interface card (NIC) in each Host PC or Server
• One to four VTrak J300s JBOD subsystems
E310s
J300s
CN1
J300s
CN1
Mgmt SAS data port
UPS
115200
8 N 1
O
I
CN3
O
I
30