Contacting Technical Support - Promise Technology VTRAK E610f Product Manual

How can I be sure everything is working OK on the VTrak?
Locally: The VTrak enclosure has LEDs on the front to monitor the status of
power, field replaceable units (FRUs) and logical drives. When these are
green, VTrak is functioning normally.
Remotely: Check the Tree Icons in WebPAM. If there are no yellow or red
warning icons displayed, VTrak is functioning normally.
What happens if a logical drive goes critical?
On the front of VTrak, the logical drive LED turns amber and an audible
alarm sounds. See "Critical & Offline Disk Arrays" on page 289.
Can VTrak run using just one power supply?
Yes, it is possible to run VTrak on a single power supply. There are two
power supplies so that VTrak will continue running if one of the power supply
fails. But deliberately leaving one power supply off negates this advantage.
In addition, leaving one power supply off reduces air flow through the VTrak
enclosure and can contribute to overheating. Always switch on both power
supplies.

Contacting Technical Support

Promise Technical Support provides several support options for Promise users to
access information and updates. We encourage you to use one of our electronic
services, which provide product information updates for the most efficient service
and support.
If you decide to contact us, please have the following information available:
• Product model and serial number
• BIOS, firmware, and driver version numbers
• A description of the problem / situation
• System configuration information, including: motherboard and CPU type,
hard drive model(s), SAS/SATA/ATA/ATAPI drives & devices, and other
controllers.
Technical Support Services
Promise Online™ Web Site http://www.promise.com/support
(technical documents, drivers, utilities, etc.)
305
Chapter 9: Support