Chapter 3: Vtrak Setup; Setting Up The Serial Connection - Promise Technology VTRAK E610f Product Manual

Chapter 3: VTrak Setup

This chapter covers the following topics:
• Setting up the Serial Connection (below)
• Choosing DHCP or a Static IP Address (page 36)
• Setting up VTrak with the CLI (page 37)
• Setting up VTrak with the CLU (page 39)
• Creating Disk Arrays with WebPAM PROe (page 42)

Setting up the Serial Connection

VTrak has a Command Line Interface (CLI) to manage all of its functions,
including customization. A subset of the CLI is the Command Line Utility (CLU), a
user-level interface that manages your VTrak via your PC's terminal emulation
program, such as Microsoft HyperTerminal. This procedure uses the serial cable
connection you made. See "Making Serial Cable Connections" on page 32.
1. Change your terminal emulation program settings to match the following
specifications:
• Bits per second: 115200
• Data bits: 8
• Parity: None
• Stop bits: 1
• Flow control: none
2. Start your PC's terminal VT100 or ANSI emulation program.
3. Press Enter once to launch the CLI.
4. At the Login prompt, type administrator and press Enter.
5. At the Password prompt, type password and press Enter.
At this point, you are in the CLI. You can continue using the CLI to make
network settings or you can switch to the CLU. Go to:
• Setting up VTrak with the CLI (page 37)
• Setting up VTrak with the CLU (page 39)
35