Single Controller Subsystem
Removing the old controller
To remove the RAID Controller on a single-controller subsystem:
1.
Shutdown the VTrak. See "Shutting Down the Subsystem" on page 103
(WebPAM PROe) or page 209 (CLU).
2.
Switch off the power.
3.
Disconnect the Fibre Channel or SAS cables, management, serial and
power cables.
4.
On the controller handle, press the release button and pull the handle
downward. See Figure 21.
5.
Pull the controller out of the VTrak enclosure.
Installing the new controller
To install the new controller:
1.
Carefully slide the controller into the enclosure.
2.
Gently press the handle in and upward until it locks. See Figure 21.
3.
Connect the Fibre Channel or SAS cables, management, serial and power
cables.
4.
Switch on the power.
The VTrak will restart. For more information about VTrak's start-up behavior,
see "Connecting the Power" on page 33.
229
Chapter 6: Maintenance