Browser Does Not Connect To Webpam Proe - Promise Technology VTRAK E610f Product Manual

Browser Does Not Connect to WebPAM PROe

If you successfully setup and connected to WebPAM PROe, then suddenly you
can no longer connect, it might be the result of the following three conditions:
• DHCP is enabled on your VTrak's virtual management port
• The DHCP server does not have a dedicated IP address for the VTrak
• The VTrak restarted and your DHCP server assigned a new IP address
You must obtain the new IP Address for the virtual management port in order to
direct your browser to the VTrak and start WebPAM PROe.
To access the new IP address:
1. Start your PC's terminal VT100 or ANSI emulation program.
2. Press Enter once to launch the CLI.
3. At the Login prompt, type administrator and press Enter.
4. At the Password prompt, type password and press Enter.
5. Type net and press Enter.
administrator@cli> net
===========================================
CId
===========================================
Virtual
The new virtual management port IP address and other network settings
display.
6. Enter the new IP address into your browser to log into WebPAM PROe.
For more information, see "Setting up the Serial Connection" on page 35 and
"Logging into WebPAM PROe" on page 42.
Port Type IP
Mgmt 192.168.10.85 255.255.255.0 192.168.10.1
Mask
301
Chapter 8: Troubleshooting
Gateway Link
Up