Chapter 9: Support; Frequently Asked Questions - Promise Technology VTRAK E610f Product Manual

Chapter 9: Support

This chapter covers the following topics:
• Frequently Asked Questions (below)
• Contacting Technical Support (page 305)
• Limited Warranty (page 308)
• Returning product for repair (page 309)

Frequently Asked Questions

What kind of disk drives can I use with VTrak?
VTrak supports 1.5 and 3.0 GB/s Serial ATA disk drives and 3.0 Gb/s SAS
drives.
Can I take the disk drives from my UltraTrak, put them into the VTrak and
keep my disk array or logical drive intact?
Yes. UltraTrak and early VTrak subsystems used a proprietary method of
disk metadata, stored in the reserve sector of each physical drive. VTrak
E-Class uses the industry-standard DDF and has a metadata-to-DDF
conversion feature. To use the conversion feature, you must restart the
VTrak after installing disk drives from an older system.
VTrak E-Class does not support Parallel ATA (PATA) disk drives.
Note that if you move the disk drives from the VTrak E610f/s or E310f/s to
the older subsystems, they will not recognize your disk array or logical drive.
How can I tell when the VTrak has fully booted?
When the VTrak is fully booted up, the Power and FRU LEDs will light up
green. If a disk array is present, the Logical Drive LED will light up green
also. The Controller heartbeat LED blinks once every two seconds.
Why does VTrak come with a Command Line Utility?
First, to assign your VTrak an IP address in order for the WebPAM
management software to connect to it. Second, in the event of a network
failure, you can still access the VTrak. Third, some users prefer the
Command Line Utility.
303