Setting Up Vtrak With The Clu; Setting System Date And Time; Making Management Port Settings - Promise Technology VTRAK E610f Product Manual

Setting up VTrak with the CLU

1. At the administrator@cli> prompt, type menu and press Enter.
The CLU main menu appears.
Figure 1. CLU main menu
2. With Quick Setup highlighted, press Enter.
The first Quick Setup screen enables you to make Date and Time settings.

Setting system date and time

1. Press the arrow keys to highlight System Date.
2. Press the backspace key to erase the current date.
3. Type the new date.
4. Follow the same procedure to set the System Time.
5. Press Ctrl-A to save these settings and move to the Management Port
configuration screen.

Making Management Port settings

By default, DHCP is disabled on VTrak and the default Management Port IP
address is set to 10.0.0.2.
Note that the IP address described here belongs to the VTrak subsystem, not to
the RAID controller. Use this IP address to log into the VTrak over your network.
Manual IP settings
To make Management Port settings manually:
1. Press the arrow keys to highlight IP Address.
39
Chapter 3: Setup