VTrak E-Class Product Manual
Creating Disk Arrays with WebPAM PROe
Setting up disk arrays with WebPAM PROe consists of the following actions:
•
Logging into WebPAM PROe (below)
•
Selecting a Language (page 44)
•
Creating a Disk Array (page 44)
•
Logging out of WebPAM PROe (page 48)
•
Using WebPAM PROe over the Internet (page 49)
•
Obtaining a Security Certificate (page 49)
Logging into WebPAM PROe
1.
Launch your Browser.
2.
In the Browser address field, type in the IP address of the VTrak subsystem.
Use the IP address you set in the CLI (page 37) or CLU (page 39). Note that
the IP address shown below is only an example. The IP address you type
into your browser will be different.
Regular Connection
•
WebPAM PROe uses an HTTP connection. . . . . . . . . . . . . . . .http://
•
Enter the VTrak's Management Port IP address . . . . 192.168.10.85
Together, your entry looks like this:
http://192.168.10.85
Secure Connection
•
WebPAM PROe uses a secure HTTP connection . . . . . . . . . .https://
•
Enter the VTrak's Management Port IP address . . . . 192.168.10.85
Together, your entry looks like this:
https://192.168.10.85
You can also use the CLU to create disk arrays and logical drives.
See Chapter 5 of the VTrak E-Class Product Manual for more
information.
Whether you select a regular or a secure connection, your login to
WebPAM PROe and your user password are always secure.
Note
Note
42