4.1.4
Opening and closing the server
4.1.4.1
Opening the server
Ê Remove the server from the system umit as described in
a PRIMERGY CX120 S1 server from the system unit" on page
V
CAUTION!
When removing a PRIMERGY CX120 S1 server from the system unit
that is not replaced immediately, always install a dummy cover in the
empty installation bay. For further information please refer to
"Installing a server dummy cover" on page
Figure 13: Opening the server (A)
Ê Loosen two screws on the server rear.
PRIMERGY CX120 S1
Service Supplement
Preparations
section "Removing
19.
26.
section
29