Programming; Program Mode - Abus Terxon SX AZ4000 Installation Instructions Manual

15 Programming

15.1

Program mode

All input in program mode is made via the keypad. The
LCD display gives you information about your input. For
further information about the programming items, see
page 30.
Proceed as follows to change an item:
1. Via the keypad, enter the three-digit number of
the menu item (e.g.,
property you want to view or change. To confirm
your input, press the Enter key
The selected menu item is shown on the LCD
display.
2. To leave a setting unchanged, press the Enter
key .
3. Otherwise, enter the new value via the keypad.
You can see possible values in the programming
table.
The new property is displayed.
4. To confirm and save the new value, press the
Enter key .
5. You can select a new item only if the LCD display
shows Installer Mode.
To exit the program menu:
1. The LCD display shows: Installer Mode.
2. Enter 099 and confirm your entry by pressing the
Enter key .
The LCD display shows: Exit Eng. ?
3. Confirm your input by pressing the Enter key
To cancel your input, press the X key
001
for Zone 1) whose
.
.
.
4. After you confirm your input with the Enter key
, the alarm centre checks the current status of
the system. If everything is correct, the alarm
centre returns to normal operating state.
You have exited the program menu. The alarm
centre is now deactivated.
5. If there are any system faults, these are now
displayed. Possible faults are:
-
Tamper contact of the alarm centre or
control unit open
-
No mains or battery power available
-
A zone is open that triggers immediate
alarm even when the alarm centre is
deactivated (24 hour, fire, tamper).
If there is a system fault, the program mode is not
exited. First clear all displayed system faults and
repeat the steps listed above.
Factory settings
Program code/
Master code:
User code 1/
Admin code:
User codes 2–16:
Threat code:
31
7890
1234
X002....X016 (not valid
until setting)
x017 (not valid until setting)
UK