Off Band Indication; Duplex Operation; The Off Band Indication, "Off," Appears On The Display; D-Pad - Icom ID-31A Advanced Instructions

Previous view
1
REPEATER AND DUPLEX OPERATIONS

■ Duplex operation

The Duplex operation shifts the transmit frequency
up or down from the receive frequency by an offset
amount.

D Setting the frequency offset

Push [MENU]
q
Push D-pad( ) to select the root item ("DUP/
w
TONE..."), and then push D-pad(Ent).

D-pad

(Ent)
(�)
Push D-pad( ) to select the "Offset Freq," and then
e
push D-pad(Ent).
Rotate [DIAL] to set the frequency offset to between
r
0.000.00 and 59.995.00 MHz, and then push D-
pad(Ent).
• The selected tuning step in the VFO mode is used when
setting the offset frequency.
• Pushing [V/MHz]
below.
TS* 1 MHz
* The frequency changes according to the preset tuning
steps. See page 23 on the printed manual for details.
Push [MENU]
t
To reset to the default value.
Push in step r as described above, then push
D-pad(Ent) to reset to the default value.
NOTE:
• The frequency offset cannot be changed in the DR
mode.
• The Auto repeater function uses the preset fre-
quency offset. Depending on the frequency offset
value, the off band indication, "OFF," appears on
the display when [PTT] is pushed. (p. 1-5)
.
(Setting example: 5.000.00)
toggles the tuning digit, as shown
10 MHz
to exit the [MENU] screen.
[DIAL]
1-4
The current frequency
offset
Rotate [DIAL], then
push D-pad(Ent).
Push
Push D-pad(Ent)
Default value