About Scans; D [Dial] Operation During A Scan; D Squelch Setting For A Scan; D Tuning Step For A Vfo Scan - Icom IC-T10 Advanced Manual

3
SCAN OPERATION

About Scans

D [DIAL] operation during a scan

z Rotate [DIAL] to change the scan direction during a
scan.
z Rotate [DIAL] to resume the scan when the scan is
paused.

D Squelch setting for a scan

You can change the squelch level to suit your
operating needs. Set the squelch level to open the
squelch, according to the received signal strength.
L Rotate [DIAL] while holding down [MONI] to adjust the
squelch level during a scan. The scan resumes after
releasing [MONI].

D Tuning step for a VFO scan

The tuning step selected in the Set mode (p. 5-4) is
applied to the scan.

D Scan Skip function

The skip function speeds up scanning by not scanning
those frequencies set as skip channels (p. 3-5).
In the VFO mode:
Skips the frequency assigned as "
In the Memory mode:
Skips the memory channel assigned as "
" " (p. 3-5).
TIP: Turn OFF the Program Skip function in the Set
mode (p. 5-4) to execute a scan, including the
skipped frequency.

D Operating mode during a scan

• The VFO scan uses the selected operating mode.
• During a Memory mode scan, the operating mode
entered into the channel is used.

D When a signal is received

When a signal is received, the scan pauses for the
period of time that is set in the Set mode. (p. 5-4)
When a received signal disappears, the scan resumes
after the set period of time.
" (p. 3-5).
" or
3-3