About "Ur?" And "Rpt?" Error Messages; D Shows "Ur; D Shows "Rpt?" Or "Rx; D Shows "L - Icom ID-31A Advanced Instructions

Previous view

■ About "UR?" and "RPT?" error messages

The transceiver includes a status message in the
signal received back from the access repeater, after
transmitting.

D Shows "UR?"

The call was successfully sent, but no station's signal
was immediately received.
The called station may have missed your call, so after
waiting for a while, try calling again.

D Shows "RPT?" or "RX"

The destination repeater was not found, there is a pro-
gramming error, or the destination repeater was busy.
When "RPT?" is displayed, after waiting for a while, try
calling again, because in a gateway call, your signal is
sent even if the destination repeater is busy.
NOTE: "RPT?" or "RX" is displayed when;
• the repeater call sign programming is error.
• your own call sign is not registered on a gate-
way repeater, or the registration contents is not
matched.
• the destination call sign is not registered on a gate-
way repeater, or the registration contents is not
matched.
• the destination repeater cannot be accessed.
• a blank MY call sign memory is selected. ("RX" is
displayed)

D Shows "L"

While operating voice communication or low-speed
data communication through the internet, some pack-
ets may be lost due to network error, or the caller's
signal is weak getting into the repeater. In such a case,
the transceiver displays "L" on the display to indicate
Packet Loss has occurred.
When the transceiver receives corrupted data, and
misidentifies it is Packet Loss, "L" is displayed, even
if it is a Local area call.
This means that your local area call was cor-
rectly sent from the "Hirano430" repeater.
This means that your gateway call was cor-
rectly sent from the "Hirano430" repeater to the
"Hamacho430" repeater.
This means that your gateway call was sent from
the "Hirano430" repeater to the "Hamacho430"
repeater, but the "Hamacho430" repeater was
busy at the time.
Shows the packet loss
3-19
DR MODE <BASIC>
"L" blinks
while packet
loss is occurring.
3
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21