Icom ID-31A Advanced Instructions page 41

Previous view
3
DR MODE <BASIC>
For your reference
■
D Making a Local Area call or Gateway call in the VFO mode (Continued)
5. Calling
!9 While holding down [PTT], speak into the micro-
phone at your normal voice level.
• The TX/RX indicator lights red.
• The S/RF meter shows the transmit output power level.
@0 Release [PTT] to receive.
Information
✓
After setting, hold down [S.MW]
enter the Select Memory write mode, and then rotate
[DIAL] to select a desired memory channel.
Hold down [S.MW]
grammed data into the channel.
• Settings for "UR" and "R2," depending on the type of call you wish to make
Destination: CQ
<Call type: Local area call>
• UR setting : CQCQCQ
• R2 setting : NOT USE
<Call type: Gateway call>
• UR setting : Destination repeater to call CQ
• R2 setting : Your gateway repeater
NOTE: The R1 setting is set to your access repeater's call sign.
for 1 second to
for 1 second to save this pro-
CQ
✱
CQ
Shows the transmit
output power level
Destination: An individual station
<Call type: Local area call>
• UR setting : An individual station
• R2 setting : NOT USE
✱
<Call type: Gateway call sign routing call>
• UR setting : An individual station
• R2 setting : Your gateway repeater
3-24
Shows it is a
repeater des-
tination call
Hirano430 call sign
scrolls with "/."