Icom ID-31A Advanced Instructions page 27

Previous view
3
DR MODE <BASIC>
"FROM" (Access repeater) setting
■
D "FROM" (Access repeater) setting using the Repeater Search function (Continued)
2. Receiving your own position data from the GPS
receiver
Hold down
q
• The DR mode is selected.
Push D-pad( ) to select "FROM," and then push D-
w 
pad(Ent).
D-pad
(Ent)
(�)
Push D-pad( ) to select "Near Repeater," and then
e 
push D-pad(Ent).
• The Repeater Search function starts. Up to 10 of the
nearest repeaters are displayed.
Push D-pad( ) to select "Hirano430," and then push
r 
D-pad(Ent).
• "Hirano430" is displayed in "FROM."
NOTE:
When using the Repeater Search function, be sure to
first receive your own position data.
• If no repeater is found, screen 1, as shown to the
right, will be displayed.
• If the last used repeater can be used, the screen 2
as shown to the right will be displayed.
for 1 second.
Shows the distance
and direction from your
position to the repeater
"Hirano430" setting is completed.
NOTE: When the position data accuracy level is set
to "Approximate," direction data is not displayed if
the distance to the repeater is under 5 kilometers.
Screen 1
3-10
Shows the call sign
of "Hirano430,"
Screen 2