Icom ID-31A Advanced Instructions page 77

Previous view
4
DR MODE <ADVANCED>
Destination call sign programming (Continued)
■
!1 Push D-pad( ) to select "CALL SIGN," and then

push D-pad(Ent).
!2 Rotate [DIAL] to select the first character.
(For example: J)
• A to Z, 0 to 9, / and a space can be selected.
• A space can be selected, even for any input mode se-
lected.
• Push [CLR]
down [CLR]
after the cursor.
!3 Push D-pad(") to move the cursor to the second
digit.
!4 Repeat steps !2 and !3 to enter a call sign of up to
8 characters, including spaces.
(For example: First, J, then M, then 1, then Z, then
L, then K.)
!5 After entering, push D-pad(Ent).
!6 Push D-pad( ) to select "<<Add Write>>," and then

push D-pad(Ent).
!7 Push D-pad( ) to select "YES," and then push D-

pad(Ent).
!8 Push [MENU]
To cancel the programmed data:
To cancel the programmed
data, push [CLR]
to display "Cancel edit?."
Push D-pad( ) to select

"YES," and then push D-
pad(Ent) to cancel pro-
gramming and the trans-
ceiver returns the YOUR
CALL SIGN screen.
to erase the selected character, or hold
to continuously erase the characters
to exit the MENU screen.
[DIAL]
When "TOM" is selected,
"JM1ZLK" is displayed here.
4-36
"JM1ZLK" is entered.
Select
When you select
"Edit" in step t on
the previous page
" < < O ve r w r i t e > > "
appears here. If
you select "<<Over-
write>>," the pro-
grammed call sign
overwrites the origi-
nal call sign.
"TOM/JM1ZLK"
is programmed
into the Your Call
Sign memory.