Gps Auto Transmission For Only Simplex; D Setting The Gps Automatic Transmission - Icom ID-31A Advanced Instructions

Previous view
5
GPS/GPS-A OPERATION

■ GPS Auto transmission for only Simplex

In the DV mode, this function automatically transmits
the GPS receiver's current position data, at a
selected interval, and should only be used in Simplex
transmission.
NOTE:
• Your own call sign must be entered to activate the GPS
automatic transmission.
• When the "GPS Select" menu on page 10-20 is set to
"OFF" or "Manual," this function is disabled.
(MENU > GPS > GPS Set > GPS Select)

D Setting the GPS automatic transmission

Push [MENU]
q
Push D-pad( ) to select the root item (GPS), and
w
then push D-pad(Ent).
D-pad
(Ent)
(�)
Push D-pad( ) to select "GPS Auto TX," and then
e
push D-pad(Ent).
Rotate [DIAL] to select a desired position data trans-
r
mit interval.
• Selectable settings are OFF, 5*, 10, 30seconds
and 1, 3, 5, 10 and 30minutes.
* If four GPS sentences are selected in GPS SEN-
TENCE menu on page 5-16, "5sec" cannot be
selected.
• Selecting "OFF" cancels the GPS automatic trans-
mission.
• The GPS message is also transmitted, if pro-
grammed.
Push [MENU]
t
NOTE:
• Use GPS automatic transmission in only the simplex
mode.
• GPS automatic transmission through a repeater may in-
terfere with other communications.
When a GPS message is programmed, the transceiver
transmits it along with the position data. See page 5-17
for the GPS message programming.
to enter the Menu screen.
to exit the Menu screen.
5-24