Memory Scan; D Setting The Skip Memory Channel - Icom ID-31A Advanced Instructions

Previous view

■ Memory scan

There two types of scan in the memory mode: Memory
scan and memory bank scan.
• Channels set as "PSKIP" or "SKIP" is skipped during
a scan.
• Two or more memory channels, which are not set as skip
channels, must be programmed into start a memory scan.

D Setting the skip memory channel

The memory channels set as "PSKIP" or "SKIP" skip
channels are not scanned.
Push [M/CALL]
q
Hold down [FM/DV]
w
Push D-pad( ) to select the scan type.
e 
• ALL : Full scan
• MODE : Mode memory scan
• DUP : Duplex scan (p. 8-2)
(For the duplex mode)
• TONE : Tone scan (For tone scanning)
D-pad
(Ent)
(�)
Push D-pad(Ent) to start the scan.
r
• If desired, rotate [DIAL] to switch the scanning direction
during a scan.
• If desired, hold down for 1 second [LOCK]
ON the Lock function during a scan.
To turn the function OFF, hold down [LOCK]
for 1 second.
• The scan resumes even while the MENU screen is dis-
played.
To cancel the scan, hold down [SCAN]
t
1 second.
• Pushing [CLR]
to select the memory mode.
for 1 second.
to turn
also cancels the scan.
[DIAL]
Blinks
When a signal is received.
Blinks
The S-meter shows the re-
again
ceived signal strength.
for
CONVENIENCE!
Holding down [SCAN]
also selects the scan type. The scan immediately
starts when [SCAN]
8-7
SCAN OPERATION
Hold down [SCAN]
for 1 second.
Push D-pad(Ent).
Blinks
Blinks
Memory channel number
and then rotating [DIAL]
is released.
8
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21