Accessories Provided With The Ap; Installation Preparation Checklist - HP 525 Installation Manual

Do not place the device on any metal surface. Place it where there are no obstacles and good
•
signal strength is available.

Accessories provided with the AP

WARNING!
Only use the antennas which have been approved by the applicant. Unapproved antenna(s) may produce
unwanted spurious or excessive RF transmitting power, which is prohibited and could be in violation of
FCC/IC limits.
Wall-mounting bracket
MAC address label
Wall anchor kit
Antennas, power adapter, and power cable are user-supplied.

Installation preparation checklist

Before you install an AP, verify the following items:
Connect the power cord and connect the AP to the network. Examine the LED status to make sure
•
the AP can operate correctly. For more information about AP LEDs, see
• Verify that cabling has been completed.
The device supports 802.3af-compliant PoE. To achieve the best performance, HP recommends that
•
you use a GE connection to the power device.
Record the MAC address and serial number of the AP (marked on the rear of the AP) for future use.
•
• If part of the power line is routed outdoors, use a power strip with lightning protection (user supplied)
to connect the power cord of the AP to the power line.
×3
T-rail holder
×2
T-rail holder mounting screw
Hex-head bolt, washer, and nut
2
×3
"Appendix B LEDs."