Setting The Antenna Mode Using The Web Interface; Setting Transmit Power Limits Using The Cli - HP procurve 420 Getting Started Manual

Setting the Antenna Mode Using the Web Interface

Select the Configuration tab.
1.
2. Click the [
Port/Radio Settings]
Scroll down to the External Antennas section at the bottom of the page.
3.
From the Antenna Mode drop-down menu, select Diversity or Single for the
4.
type of antenna attached to the access point.
5. Click the
[Apply Changes]
Antenna Mode selection;
Diversity or Single.

Setting Transmit Power Limits Using the CLI

1. Type configure to enter global configuration mode.
HP420#configure
Enter configuration commands, one per line. End with
CTRL/Z
HP420(config)#
Using an External Antenna with the Access Point 420
button.
button.
Installation Procedures
4-9