Cli: Setting Snmp Parameters - HP procurve 420 Management And Configuration Manual
Hide thumbs
Also See for procurve 420:
- Management and configuration manual (257 pages) ,
- Getting started manual (94 pages) ,
- Installation and getting started manual (78 pages)
Table of Contents
Advertisement
Figure 5-4. The SNMP Window
CLI: Setting SNMP Parameters
CLI Commands Used in This Section
Command Syntax
[no] snmp-server enable server
[no] snmp-server community <string> [ro | rw]
[no] snmp-server host <host_ip_address |
host_name> <community-string>
[no] snmp-server contact <string>
[no] snmp-server location <text>
show snmp
Access Point Configuration
Configuring SNMP
CLI Reference Page
page 6-27
page 6-25
page 6-28
page 6-26
page 6-29
page 6-30
5-15
Advertisement
Table of Contents
Need help?
Do you have a question about the procurve 420 and is the answer not in the manual?