Link Aggregation Configuration; Configuring A Manual Aggregation Group - H3C S5100-SI Series Operation Manual

Operation Manual – Link Aggregation
H3C S5100-SI/EI Series Ethernet Switches

1.4 Link Aggregation Configuration

Caution:
The commands of link aggregation cannot be configured with the commands of port
loopback detection feature at the same time.
The ports where the mac-address max-mac-count command is configured cannot
be added to an aggregation group. Contrarily, the mac-address max-mac-count
command cannot be configured on a port that has already been added to an
aggregation group.
MAC-authentication-enabled ports and 802.1x-enabled ports cannot be added to an
aggregation group.
Mirroring destination ports and mirroring reflector ports cannot be added to an
aggregation group.
Ports configured with blackhole MAC addresses, static MAC addresses, multicast
MAC addresses, or the static ARP protocol cannot be added to an aggregation
group.
Ports where the IP-MAC address binding is configured cannot be added to an
aggregation group.
Port-security-enabled ports cannot be added to an aggregation group.
The port with Voice VLAN enabled cannot be added to an aggregation group.
Do not add ports with IP filtering enabled to an aggregation group.
Do not add ports with ARP intrusion detection enabled to an aggregation group.
Do not add ports with source IP addresses/source MAC addresses statically bound
to them to an aggregation group.
A port belonging to a port group cannot be added to an aggregation group.
Conversely, a port belonging to an aggregation group cannot be added to a port
group.

1.4.1 Configuring a Manual Aggregation Group

You can create a manual aggregation group, or remove an existing manual aggregation
group (after that, all the member ports will be removed from the group).
For a manual aggregation group, a port can only be manually added/removed to/from
the manual aggregation group.
Chapter 1 Link Aggregation Configuration
1-7