H3C S5100-SI Series Operation Manual page 792

Operation Manual – System Maintenance and Debugging
H3C S5100-SI/EI Series Ethernet Switches
Debugging
information
Protocol
debugging
switch
Screen
output
switch
Figure 2-1 The relationship between the protocol and screen debugging switch
Note:
Displaying debugging information on the terminal is the most commonly used way to
output debugging information. You can also output debugging information to other
directions. For details, refer to Information Center Operation.
You can use the following commands to enable the two switches.
Follow these steps to enable debugging and terminal display for a specific module:
Enable system debugging
for specific module
Enable terminal display
for debugging
Caution:
The output of debugging information affects the system operation. Disable all
debugging after you finish the system debugging.
1 2
ON
ON
OFF
OFF
To do...
debugging module-name
[ debugging-option ]
terminal debugging
Chapter 2 Basic System Configuration
Debugging
information
3
Protocol
debugging
switch
Screen
output
switch
Use the command...
2-3
and Debugging
1 2 3
ON
OFF
ON
Remarks
Required
Disabled for all modules
by default.
Required
Disabled by default.