Qos Profile Configuration; Configuring A Qos Profile - H3C S5100-SI Series Operation Manual

The switch generates a new QoS profile by adding user source MAC address
information to the traffic classification rule defined in the existing QoS profile and then
applies the new QoS profile to the port the user is connected to.
Port-based QoS profile application
The switch directly applies the QoS profile to the port the user is connected to.
Note:
A user-based QoS profile application fails if the traffic classification rule defined in the
QoS profile contains source address information (source MAC address information,
source IP address information, or both).
II. Manual application mode
You can use the apply command to manually apply a QoS profile to a port.

2.2 QoS Profile Configuration

Complete the following tasks to configure a QoS profile:

Configuring a QoS Profile

Applying a QoS Profile
2.2.1 Configuring a QoS Profile
I. Configuration prerequisites
The ACL rules used for traffic classification have been defined. Refer to the ACL
module of this manual for information about defining ACL rules.
The type and number of actions in the QoS profile have been determined.
Task
Required
Required
2-2
Remarks