Operation Manual – MSTP
H3C S5100-SI/EI Series Ethernet Switches
<Sysname> system-view
[Sysname] stp interface GigabitEthernet 1/0/1 edged-port enable
2)
Configure GigabitEthernet 1/0/1 as an edge port in Ethernet port view
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] stp edged-port enable
1.3.13 Specifying Whether the Link Connected to a Port Is Point-to-point
Link
A point-to-point link directly connects two switches. If the roles of the two ports at the
two ends of a point-to-point link meet certain criteria, the two ports can turn to the
forwarding state rapidly by exchanging synchronization packets, thus reducing the
forward delay.
You can determine whether or not the link connected to a port is a point-to-point link in
one of the following two ways.
I. Specify whether the link connected to a port is point-to-point link in system
view
Follow these steps to specify whether the link connected to a port is point-to-point link in
system view:
Enter system view
Specify whether the
link connected to a port
is point-to-point link
II. Specify whether the link connected to a port is point-to-point link in
Ethernet port view
Follow these steps to specify whether the link connected to a port is point-to-point link in
Ethernet port view:
Enter system view
Enter Ethernet port view
Specify whether the link
connected to a port is a
point-to-point link
To do...
system-view
stp interface interface-list
point-to-point { force-true |
force-false | auto }
To do...
system-view
interface interface-type
interface-number
stp point-to-point
{ force-true | force-false |
auto }
Use the command...
Use the command...
1-33
Chapter 1 MSTP Configuration
Remarks
—
Required
The auto keyword is
adopted by default.
Remarks
—
—
Required
The auto keyword is
adopted by default.