Ignoring The Authorization Information From The Radius Server; Configuring Security Mac Addresses - H3C S5100-SI Series Operation Manual

Operation Manual – Port Security-Port Binding
H3C S5100-SI/EI Series Ethernet Switches
III. Configuring the Trap feature
Follow these steps to configure port security trapping:
Enter system view
Enable sending traps for
the specified type of event

1.2.5 Ignoring the Authorization Information from the RADIUS Server

After an 802.1x user or MAC-authenticated user passes Remote Authentication Dial-In
User Service (RADIUS) authentication, the RADIUS server delivers the authorization
information to the device. You can configure a port to ignore the authorization
information from the RADIUS server.
Follow these steps to configure a port to ignore the authorization information from the
RADIUS server:
Enter system view
Enter Ethernet port view
Ignore the authorization
information from the
RADIUS server

1.2.6 Configuring Security MAC Addresses

Security MAC addresses are special MAC addresses that never age out. One security
MAC address can be added to only one port in the same VLAN so that you can bind a
MAC address to one port in the same VLAN.
Security MAC addresses can be learned by the auto-learn function of port security or
manually configured.
Before adding security MAC addresses to a port, you must configure the port security
mode to autolearn. After this configuration, the port changes its way of learning MAC
addresses as follows.
The port deletes original dynamic MAC addresses;
To do...
system-view
port-security trap { addresslearned
| dot1xlogfailure | dot1xlogoff |
dot1xlogon | intrusion |
ralmlogfailure | ralmlogoff |
ralmlogon }
To do...
system-view
interface interface-type
interface-number
port-security
authorization ignore
Chapter 1 Port Security Configuration
Use the command...
Use the command...
1-10
Remarks
—
Required
By default, no
trap is sent.
Remarks
—
—
Required
By default, a port uses the
authorization information
from the RADIUS server.