Monitor Link Configuration Example; Implementing Collaboration Between Smart Link And Monitor Link - H3C S5100-SI Series Operation Manual

Operation Manual – Smart Link-Monitor Link
H3C S5100-SI/EI Series Ethernet Switches

2.4 Monitor Link Configuration Example

2.4.1 Implementing Collaboration Between Smart Link and Monitor Link

I. Network requirements
As shown in
Configure Smart Link and Monitor Link to prevent the PCs from failing to access the
server and Internet due to uplink link or port failure.
II. Network diagram
Switch C
GE1/0/3
GE1/0/1
Switch A
PC 1
Figure 2-3 Network diagram for Monitor Link configuration
III. Configuration procedure
1) Enable Smart Link on Switch A and Switch B to implement link redundancy
backup. Perform the following configuration on Switch A. The configuration on
Switch B is the same as on Switch A.
# Enter system view.
<switchA> system-view
# Enter
GigabitEthernet1/0/2.
[SwitchA] interface GigabitEthernet 1/0/1
[SwitchA-GigabitEthernet1/0/1] stp disable
Figure 2-3, the PCs access the server and Internet through the switch.
GE1/0/10 GE1/0/11
Switch E
GE1/0/1 GE1/0/1
GE1/0/2 GE1/0/2
BLOCK
GE1/0/2 GE1/0/2
PC 2 PC 3
Ethernet port view.
Chapter 2 Monitor Link Configuration
Server
Switch D
GE1/0/3
GE1/0/1
Switch B
PC 4
Disable STP on
2-6
GigabitEthernet1/0/1 and