Hwping Server Configuration; Hwping Client Configuration - H3C S5100-SI Series Operation Manual

Operation Manual – HWPing
H3C S5100-SI/EI Series Ethernet Switches
1.2 HWPing Configuration
The TCP/UDP/jitter tests need the cooperation of HWPing client and HWPing server.
Other types of tests need to configure HWPing client and corresponding different
servers.
You can enable both the HWPing client and HWPing server functions on an H3C
S5100SI/EI Ethernet switch, that is, the switch can serve as a HWPing client and server
simultaneously.

1.2.1 HWPing Server Configuration

The following table describes the configuration on HWPing server, which is the same
for HWPing test types that need to configure HWPing server.
Follow these steps to perform HWPing server configurations:
To do...
Enter system view
Enable the HWPing
server function
Configure a UDP
listening service
Configure a TCP
listening service
Note that:
The HWPing server function is needed only for jitter, TCP, and UDP tests.
You can configure multiple TCP/UDP listening services on one HWPing server,
with each listening service corresponding to a specific destination IP address and
port number.

1.2.2 HWPing Client Configuration

I. HWPing client configuration
After HWPing client is enabled, you can create multiple test groups for different tests,
without the need to enable HWPing client repeatedly for each test group.
Different types of HWPing tests are somewhat different in parameters and parameter
ranges. The following text describes the configuration on HWPing client for different
test types.
Use the command...
system-view
hwping-server enable
hwping-server
udpecho ip-address
port-num
hwping-server
tcpconnect ip-address
port-num
1-5
Chapter 1 HWPing Configuration
Remarks
—
Required
Disabled by default.
Required for UDP and jitter tests
By default, no UDP listening
service is configured.
Required for TCP tests
By default, no TCP listening
service is configured.