Port Isolation Configuration Example; Displaying And Maintaining Port Isolation Configuration - H3C S5100-SI Series Operation Manual

Operation Manual – Port Isolation
H3C S5100-SI/EI Series Ethernet Switches
Note:
When a member port of an aggregation group joins/leaves an isolation group, the
other ports in the same aggregation group will join/leave the isolation group at the
same time.
For ports that belong to an aggregation group and an isolation group simultaneously,
removing a port from the aggregation group has no effect on the other ports. That is,
the rest ports remain in the aggregation group and the isolation group.
Ports that belong to an aggregation group and an isolation group simultaneously are
still isolated even when you remove the aggregation group in system view.
Adding an isolated port to an aggregation group causes all the ports in the
aggregation group on the local unit to be added to the isolation group.

1.3 Displaying and Maintaining Port Isolation Configuration

Display information about
the Ethernet ports added
to the isolation group

1.4 Port Isolation Configuration Example

I. Network requirements
As shown in
GigabitEthernet1/0/2, GigabitEthernet1/0/3, and GigabitEthernet1/0/4 respectively.
The switch connects to the Internet through GigabitEthernet1/0/1.
It is desired to isolate PC2, PC3 and PC4 to disable them from communicating directly
with each other.
To do ...
display isolate port
Figure 1-1
, PC2, PC3 and PC4 connect to the switch ports
Chapter 1 Port Isolation Configuration
Use the command ...
1-2
Remarks
Available in any view