Configuring The Current Port As An Edge Port - H3C S5100-SI Series Operation Manual

Operation Manual – MSTP
H3C S5100-SI/EI Series Ethernet Switches
To do...
Enter system view
Configure the
maximum
transmitting rate for
specified ports
II. Configure the maximum transmitting rate in Ethernet port view
Follow these steps to configure the maximum transmitting rate in Ethernet port view:
Enter system view
Enter Ethernet port view
Configure the maximum
transmitting rate
As the maximum transmitting rate parameter determines the number of the
configuration BPDUs transmitted in each hello time, set it to a proper value to prevent
MSTP from occupying too many network resources. The default value is
recommended.
III. Configuration example
# Set the maximum transmitting rate of GigabitEthernet 1/0/1 to 15.
1) Configure the maximum transmitting rate in system view
<Sysname> system-view
[Sysname] stp interface GigabitEthernet 1/0/1 transmit-limit 15
2) Configure the maximum transmitting rate in Ethernet port view
<Sysname> system-view
[Sysname] interface GigabitEthernet 1/0/1
[Sysname-GigabitEthernet1/0/1] stp transmit-limit 15

1.3.12 Configuring the Current Port as an Edge Port

Edge ports are ports that neither directly connects to other switches nor indirectly
connects to other switches through network segments. After a port is configured as an
edge port, the rapid transition mechanism is applicable to the port. That is, when the
Use the command...
system-view
stp interface
interface-list
transmit-limit
packetnum
To do...
system-view
interface interface-type
interface-number
stp transmit-limit
packetnum
—
Required
The maximum transmitting rate of
all Ethernet ports on a switch
defaults to 10.
Use the command...
1-31
Chapter 1 MSTP Configuration
Remarks
Remarks
—
—
Required
The maximum
transmitting rate of all
Ethernet ports on a switch
defaults to 10.