Habp Client Configuration; Displaying And Maintaining Habp Configuration - H3C S5100-SI Series Operation Manual

Operation Manual – 802.1x and System Guard
H3C S5100-SI/EI Series Ethernet Switches
To do...
Configure the
current switch to
be an HABP
server
Configure the
interval to send
HABP request
packets.

3.3 HABP Client Configuration

HABP clients reside on switches attached to HABP servers. After you enable HABP for
a switch, the switch operates as an HABP client by default. So you only need to enable
HABP on a switch to make it an HABP client.
Follow these steps to configure an HABP client:
To do...
Enter system view
Enable HABP

3.4 Displaying and Maintaining HABP Configuration

Display HABP
configuration and status
Display the MAC address
table maintained by HABP
Display statistics on HABP
packets
Use the command...
habp server vlan vlan-id
habp timer interval
Use the command...
system-view
habp enable
To do...
display habp
display habp table
display habp traffic
Required
By default, a switch operates as
an HABP client after you enable
HABP on the switch. If you want
to use the switch as a
management switch, you need to
configure the switch to be an
HABP server.
Optional
The default interval for an HABP
server to send HABP request
packets is 20 seconds.
—
Optional
HABP is enabled by default. And a
switch operates as an HABP client
after you enable HABP for it.
Use the command...
3-2
Chapter 3 HABP Configuration
Remarks
Remarks
Remarks
Available in any view
Available in any view
Available in any view